V-Carve Inlay with Estlcam – Solved
I’ve wanted to do some wooden inlays for a while. I’m reluctant to learn any new software since Estlcam has been awesome to use for everything else. I’m sure there will be a need to move on at some point, but that time is not today 🙂 I did buy a month subscription for Carveco to complete an inlay, but it turns out I didn’t need it. I found a way to perform the same functions in Estlcam. By following most of this tutorial for Carveco, I was able to use the same basic idea in Estlcam. The basics behind why it works: WARNING – Manually start your spindle before starting the male carving as its “Start layer” is 5mm below the timber surface. If needed, add a have a small shape to mill at… Read More »V-Carve Inlay with Estlcam – Solved